I appreciate the ideas, Monday I return to work I'll post some before and after pics as to show what I was working with and progress on this job, this job was literally scrap to a functioning unit, everything has been over looked, replaced, and or installed, started with bare frame and motor to a working lift, I do have a spare harness and fuse block I can look over, I have the schematics I will share incase someone else is in need of it and maybe someone can help point me in the right direction if I'm over looking something major, to answer your question, when running the tests I did have oil pressure, unit will run without the oil pressure wire hooked up (found that out because someone seemed to have cut the wire to mess with me) truck would die after not sensing the oil pressure after about 10-15 seconds, and I would read RPMs and Crank variables on the graph