I dug a bit deeper into the issue with my forklift and decided to look at the drive print. On the front side you can see 3 white/blueish resistors/transistors. I found the 2 white ones to be very loose on the board. Looking at the back you can see that there is somewhat of a burn mark where they are soldered to the print. I can wiggle them around by hand but I can't just pull them out.

I figured a bad contact could be the issue here so I turned the ignition on a few times and tried the pedal. Issue still remained. After that I tried to wiggle these resistors once more by hand and found the outher white one to be cold and the middle one to be extremely hot ( I burned my thumb on it).

Could this be an indication to something?

Any way to put some pictures on here?