hi max_h
forum constraints do not allow email addresses inside the posts
you can add it in your forum profile in the signature area if you like and it will show up at the bottom of your posts or you can click on my name or look at my posts and get my email and send me one

would prefer posting a new thread here though and dealing with it in the forum so others can learn from it hopefully ;o)

But to address your code 47
basically you probably have a bad connection at the controller for your pump controller (the one on the right hand side), check the cable terminals, make sure none are burnt, and are all tight. Pay close attention to the post on the controller when you check the tightness, if the post moves or turns at all then it is more than likely broken off from it's solder point on the conductor plate it is soldered to. If this is the case then you will need a new or reman controller, these are cold soldered to the plates and cannot be repaired in the field.