1. Home
  2. Forums
  3. Report post

Report this forum post

With key on you should have batt+ to pin23, 21, 22. Batt- to pins 19,20. On the ECU connector. This is a good place to start.
  • Posted 28 Sep 2018 01:12
  • By BREWSKI
  • joined 10 Jan'12 - 1,699 messages
  • Nebraska, United States

This is ONLY to be used to report flooding, spam, advertising and problematic (harassing, abusive or crude) posts.

Indicates mandatory field

Showcased in the Virtual Expo

Last Week's Most Read
edition #1235 - 19 June 2025
Movers & Shakers
Jeannette Walker Jeannette Walker
Jeannette Walker
CEO, MHEDA
Stéphane Hénon
President, European Rental Association (ERA)
Tejal Ranjan
Chief marketing officer, JLT Mobile Computers
Pete Stanislawczyk
Chief executive officer, East Penn Manufacturing
From the forum discussions …
"Unicarriers - it would have to be for a dual fuel unit also. Usually a bad cam or crankshaft sensor will throw a E-27 or a E-28 code on the dash panel... If it does not light up and the bulb is bad then it will not start also."
mwjago, United States
Read & Post in our Forums

Showcased in the Virtual Expo

Movers & Shakers
Jeannette Walker Jeannette Walker
Jeannette Walker
CEO, MHEDA
Stéphane Hénon
President, European Rental Association (ERA)
Tejal Ranjan
Chief marketing officer, JLT Mobile Computers
Pete Stanislawczyk
Chief executive officer, East Penn Manufacturing
Nagano NUZ090D
Nagano NUZ090D 2006
Yokohama, Japan
Used - Sale
Crown RD572513TT6860R
Crown RD572513TT6860R
Braeside, Melbourne, Victoria, Australia
Hire
|
Forklift Diaries
From the forum discussions …
"Toyota 8FGCU30 - thanks to several Techs- Also check the diaphragm in the mixer, have seen a lot that stick and cause the same issue"
John_Bradley, United States
Read & Post in our Forums
Machinery-onQ
Machinery-onQ.com is the one place to source and sell all your new and used machinery.
Find equipment for sale | Add a listing
VISIT
machinery-onQ.com
Machinery-onQ