Hello I bought Linde H25t with not working lift and left right move.It have errors for joystick and I changed with new one.Now no errors but still doesn't don't lift and move left right.Oil is at correct level. I checked and fuses ,cable from joystick to Ecu,all is ok.Serial number is h2s392s00992
Showing items 16 - 20 of 20 results.
Hi, If you remove the little plastic cover off the bottom of your old joystick you can actually see the tracks of the potentiometers. Spray some contact cleaner in and work a little. This may get old working again for you to prove.
I have checked all fuses and plugs under fuse and ecu.Didn't find nothing.I think problem is ecu.Also check wiring from joystick to ecu there are Ok.And If I put broken joystick it give errors.With good one doesn't have errors but not still not working.
If anything electrical you would get a code
Sounds as though no fuse or no negative
You could have a faulty controller also
Look beside seat in armrest there is a cover remove it and make sure the plugs are all plugged in the cover pops on
Hi,tilt working, forward backward working.I try to change relays but nothing.Lift not working and left right not working.On this command engine doesn't rev. i try change of coils also nothing.On display doesn't have any faults.
Does it tilt ? Are any lights on display ?
Does in drive forward and reverse ?
Do you hear any engine change when requesting lift or side shift ?
I ask these questions to verify switch inputs from brake , seat switch and seat belt
Do you have a fuse and relay diagram ?
You can start by pushing on all relays to make sure they are seated I will wait for your reply for further assistance
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.