IMPCO vacuum line diagram - Technical Troubleshooting discussion in Forkliftaction's forums

Hyster H177:
IMPCO vacuum line diagram

I have a Hyster H177 forklift. I think it is early 90s. A rat chewed my sparkplug wires and vacuum lines and I cannot figure out where the lines go.

Anyone know of a diagram or install instructions for a IMPCO fuel system?

Vaporizer Cobra CB-30177, 400917
Mixer Part # 1468570, Serial # 000619

Posted 23 Nov 2024 09:47
Discussion started by Clint_Bingham
Texas, United States

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

Clint,

Looking at the mixer, there are two connections. The higher one goes to the lock-off. The lower one goes to the regulator. There is a third line that comes from an actuator to a check valve then to the governor. If this does not fit your lift, send the engine make and size. Good Luck

Posted 4 Dec 2024 00:57
Reply by Fishmech
Virginia, United States

The hard to do we do right away. The impossible just takes a little longer.

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.