fault code ER 137 - Technical Troubleshooting discussion in Forkliftaction's forums

Jungheinrich ETX K150:
fault code ER 137

hi guys im looking for information on this machine i have lift and steering but no drive.machine starts up ok but when drive is selected fault code ER 137 flashes on the dash.
any help would be great thanks

Posted 14 Mar 2013 06:52
Discussion started by Mag1
CO DUBLIN, Ireland

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

Meaning: Driver release driver: VZA controls driver but driver checkback signal missing.
Effect: Driving switched off (drive, Mikropils, brake)
Possible cause: driver on SK-VZA defective.
Measure: status analysis MZ-100, visually inspect SK-VZA, replace if necessaary. Before starting check the protection circuit of the drive contactors.
VZA: is the driver compartment processing unit
Also check the microfuses. The cards in the VZA and VZK are interchageable, so you might be able to identify a faulty card by swapping. There are some measures to be taken before swapping. If you need these email me.

Posted 7 Dec 2013 00:12
Reply by Roibeard
Dublin, Ireland

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.