Dead Wave - Technical Troubleshooting discussion in Forkliftaction's forums

Crown WAV50-84:
Dead Wave

Hey all,
I have a wave that is completely dead. The batteries are ok ( I charged them and made sure they were still plugged in) and so are the fuses. All the wires I can see seem to be ok as well. But the wave will not turn on at all, I can't even switch it to push mode. It's as if the batteries aren't even there. Any ideas to what's causing this?

Posted 16 Feb 2017 01:25
Modified 16 Feb 2017 01:26 by poster
Discussion started by zach_m
Illinois, United States

Acts 2:37-39

Post a Reply Report this post

Showing items 1 - 4 of 4 results.

Sort messages by:

Drop down service panel, next to the charge socket.

Posted 11 Mar 2017 12:04
Reply by techno_nz
Canterbury, New Zealand

Post a Reply Report this post

Well the key switch is good and so are the e-stops and the plugs. I've checked a few different fuses, but I don't know which is number one. Where's that one located?

Posted 3 Mar 2017 00:51
Reply by zach_m
Illinois, United States

Post a Reply Report this post

Check the plugs at the top of the flip down service panel where the drive/tow switch is. If they are ok then check the fuse #1 and wiring to it on service panel.

Posted 27 Feb 2017 10:17
Reply by popeye
Ohio, United States

Post a Reply Report this post

try testing and checking the key switch, might be bad.

Posted 25 Feb 2017 18:24
Reply by ynot
California, United States

Post a Reply Report this post

Having trouble using the Discussion Forums? Contact us for help.

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.