clicking / hesitates - Technical Troubleshooting discussion in Forkliftaction's forums

Crown RC3000:
clicking / hesitates

Clicks and hesitates before finally going forward. Reverse OK. I was told it need brushes. I'm pretty handy. Can someone confirm this diagnosis and tell me if a brave newby should attempt the repair or is a pro necessary?

Posted 10 Aug 2011 08:51
Discussion started by davidca
California, United States

David

Post a Reply Report this post

Showing items 1 - 2 of 2 results.

Sort messages by:

check your drive potentiometer

Posted 27 Sep 2011 19:29
Reply by crownie
Victoria, Australia

Post a Reply Report this post

Yes it could be brushes. If you do replace them check to see if they are uneven, if so a comm atone may he needed to smooth out the armature. I would also check the forward and reverse contractor tips for any pitting sticking or burning. I have this issue with the large number of RC's at my customers account. Verify the fed/rev switches are good do a volt drop test to determine this. I would say the issue is in the switches being faulty or may just need to be adjusted. Good luck!

Posted 10 Aug 2011 09:56
Reply by sirthor1881
Georgia, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.