Wiring on alternator - Technical Troubleshooting discussion in Forkliftaction's forums

Unicarriers (& Nissan) NISSAN 50:
Wiring on alternator

I am trying to help a friend of mine who has an old Nissan Forklift. The model listed on data plate is PHO2A25V.
I had the alternator tested at NAPA today and its charging. It is a 40 amp alternator.

The two wires that are cut is close to back of where a connector should plug in. One wire is a solid white wire. It has 12 volts all the time. Looks to be maybe 16 gauge wire ? I think that one should go to the sense terminal on back of alternator but not sure ?

Other one is white with red stripe. It has no power on it with or without key turned on. I believe that wire one would go to the L terminal but would need battery voltage when key is turned on ? I just need to find why no power with key on. Am I on the right track in thinking this ?
It also is grounded on the E terminal.

Thanks for any help. Mr Dillan

Posted 30 Oct 2024 11:32
Modified 1 Nov 2024 09:44 by poster
Discussion started by mrdillan
Alabama, United States

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

Its fixed.
Under the dash I found a fuse missing that fed the exciter wire. Replaced with a 10 amp and wired white with red stripe to L terminal on back of alternator. That wire is now showing 11.5 volts when I turn the key on. Solid white wire has 12.6 volts all the time and I connected it to the sense terminal. Its now charging 14.5 volts. All is good.

Posted 1 Nov 2024 09:41
Reply by mrdillan
Alabama, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.