I have a truck that has an intermittent problem. When parkbrake is released and I try to go forword or reverse, sometimes in seems as brakes are still applied and truck is trying to go but doesn't move. Let it sit for about 30 minutes or so, try it again and then it will move.
I get no codes, I changed and adjusted swithes at brake valve, hydraulic fluid is full.
Any help is greatly appreciated
Showing items 1 - 6 of 6 results.
also check the rod under the floor board that goes through the pedals. sometimes the rod will shift
Is it 39x truck?
Any fault codes on the display?
no drive in forward and reverse after first start up.sometime i can feel it trying to move but not.and does not rev at first as well.
found brake valve block leaking replaced still the same.
but if you push down on the rev pedal very slowly it will move but it wont do it in forward.
when it move in rev then the truck will drive around ok.when truck is turn off then go back to it wont drive unless you press down on the rev pedal very slowly.
dont think same problem as motor fault would not stop hydraulics,unless your not getting boost pressure. any more info, fault codes etc
I have an H25 CT (lp) that has no travel or lift / lower. Sounds about like the same problem?
my guess is you have a 39x your problem is with the drive motor brakes not releasing, this is normally caused by driver using emergancy foot brake constantly.the bad news is you will probably need the motor resealing ,not cheap
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.