Release Parking Brake Error -04 - Technical Troubleshooting discussion in Forkliftaction's forums

Crown SC4000:
Release Parking Brake Error -04

Crown SC4000. Almost consistently throws the -04 release parking brake code after 5 seconds of travel. Sometimes it will run fine but usually just have to throw it back into neutral and drive every 5 seconds. Figured it was a sensor so tried unplugging the on under the dash for the parking brake and also one under the brake lever with no change. Also tried loosening parking brake drastically in case it was just barely pulling somewhere. Open to other ideas to diagnose.

Posted 8 Dec 2022 03:45
Discussion started by Ryan231
Kentucky, United States

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

It'll definitely be the switches, I'd adjust the one on the handbrake lever, under the dash, it's slotted and you can pivot the switch for correct adjustment. Very tempromental and fiddly little things those switches.

Posted 11 Dec 2022 19:31
Reply by Forking_Around
New Zealand

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.