No ignition or power on the display. - Technical Troubleshooting discussion in Forkliftaction's forums

Hyster S80FT:
No ignition or power on the display.

Went to start up my FL and nothing. Battery is resting at 13v. I checked all of the fuses and they have continuity. I even swapped the key switch module with another of my Hysters and nothing. I did pull the harness that goes into the bottom of the column display and none of the pins have 12v either.

Where do I go from here?

Posted 16 Dec 2020 03:46
Discussion started by JoeFox
Louisiana, United States

Joe Fox

Post a Reply Report this post

Showing items 1 - 2 of 2 results.

Sort messages by:

Did you find the issue? I have the same problem....

Posted 23 May 2024 17:11
Reply by Gareth_hughes
United Kingdom

Post a Reply Report this post

You need to start from the beginning. Is there power anywhere in your fuse/relay box? Those can be bad for problems inside. Check for "B+" and B- at the fuse box and then go to the fuses/sockets and check there.

Posted 28 Dec 2020 05:05
Reply by PorkChop
Ontario, Canada

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.