Showing items 1 - 8 of 8 results.
hi luis,
they have GE SR controllers for the drive and a GE SP controller for the hydraulic pump (if it has SCR hydraulics). Otherwise the hydraulic would be a contactor controlled system.
Hi,
Can I have the controllers type this forklift has? I am haviung an issue with the controller of the left motor
Thank you,
Luis
Magnetic sensors, I think you're right about that. I'll be at customers local tomorrow and try the suggested repairs and keep you posted. Thanks again,
Ray
well it could be led sensors, they also could be hall effect magnetic sensors
it is not clear in the parts book i'm looking at
you can still try cleaning it, pull the wire connectors apart where the harness plugs into the circuit board and check the pins and connections, make sure all the pins are fully locked in place and none are pushed back, clean those connections also.
I'll try that and keep you posted. Much thanks for your input.
Ok that has led sensors that emit light beams and when the lever moves it breaks the beam that activates the motor.
Try using some contact cleaner to clean the LEDs, one may have some dirt in it.
Then blow it dry with air.
If that doesn't work then the board might be shorted.
There's a printed circuit board where the control levers are mounted with what looks like possible proximity sensors for each lever.
There's also a red light on the print board that stay illuminated when key is on. Is it possible the print board is shorted?
you have a function switch/sensor on the hyd lever assy either stuck or out of adjustment.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.