1. Home
  2. Forums
  3. Technical Troubleshooting

Unicarriers (& Nissan) PD01A18PQ:
Transmission

Transmission will not shift forward, but will reverse/backup
  • Posted 22 Feb 2019 09:04
  • Discussion started by adesho
  • Georgia, United States
Post a ReplyReport this post
Showing items 1 - 1 of 1 results.
what type of direction lever is it. On the steer column or finger tip control. FTC switches cab get dirty quite easily. There are some yellow diodes In the wiring loom that make it switch. You can check the switch operation in the dash panel and also check the output from transmission solenoid.
  • Posted 1 Aug 2019 00:08
  • Reply by CHRISCARRYLIFT
  • 0000, United Kingdom
Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.

Forklift Diaries
Global Industry News
edition #1228 - 1 May 2025
There is simply no ignoring the push for a greener, more sustainable materials handling equipment industry as manufacturers and customers alike seek eco-friendly solutions to reduce or eliminate carbon emissions... Continue reading
Machinery-onQ
Machinery-onQ.com is the one place to source and sell all your new and used machinery.
Find equipment for sale | Add a listing
VISIT
machinery-onQ.com
Machinery-onQ
From the forum discussions …
"JLG 2630ES:...These lifts pots can be a hassle...if you replaced them..make sure you changed wiring..they come set normally open..."
Matthew_Reed, United States
Read & Post in our Forums
Your Focus
Stuart Taylor
The critical role of managers in MH safety
Stuart Taylor
Read blog
Fact of the week
On average, people read 10-30% slower from a screen than from paper.
Crown RD572513TT6860R
Crown RD572513TT6860R
Braeside, Melbourne, Victoria, Australia
Hire
Crown CG33P5
Crown CG33P5
Braeside, Melbourne, Victoria, Australia
Hire
|

Showcased in the Virtual Expo

From the forum discussions …
"Remove the coils and ohm out the pins. Coils take a different number than regular 4y plugs... If code is there then it is an ecu issue."
ron_k, United States
Read & Post in our Forums
Movers & Shakers
Linda Häkkilä Linda Häkkilä
Linda Häkkilä
vice president, Investor Relations, Konecranes
Rhiannon Stone
vice president operations, Elokon Group
Bennit Schmieder
President, EP Equipment Europe
Mathias Höglund
Senior vice president human resources, Kalmar