Showing items 1 - 4 of 4 results.
That is what i did. I tried from 5 ohm up to 20 ohm from the battery neg to pin 6 on connector 402 and had no luck. It actually caused another internal access code that would never clear unless the resistor was removed. Who knows things get weird.
You wont find it in any book. You will need to install a resistor off the main B- on acc 3. The specifics are in my previous post on this issue. 5-10 ohm resistor to the pc402-6 wire.
thanks PES I tried several different configurations of resistors to pin 6 and had no luck and had to replace the access 3 to correct the issue
It's an internal access fault.
Run a jumper from the center neg lead on access 3 to pc402-6.
You will need to put a 5-10 ohm resistor in that line. The stonger the better. This will beed voltage and will correct the issue.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.