Showing items 1 - 9 of 9 results.
Handle could be getting stuck causing pot 1, pot two or optical switch to stay on. Start with the basics. Check pot 1, pot 2 and opticals. Lube the back of the handle, clean the opticals and calibrate the pots. Re-check and go from there. Good luck
I think its probably one of the optical sensors in the handle sticking on. Might be able to clean but will probably need to be replaced.
If you swapp out access 3 does it have to all be re configured by crown or will it just start up normal?
It is not seeing you on the pedals. You can check them through the analyzer 2 inputs DMS and BKS then see if they are bad or if wiring or a blown fuse problem.
Only when i move my handle
Only when i move my handle
Does it show "center handle" when handle is at rest or only when you operate or move handle. If only when you move handle then is it all functions or just travel. If it doesn't show center handle at rest its likely not your handle but a sequence error.or failed module
An Access3 traction module that has failed may give you this operator level error. If calibration does not work you may try swapping Access3 with a known good one.
Could be as simple as calibrating POT1 and/or POT2. Also could be an issue with fwd/rev switches (optical switches). FYI a complete handle assy for an RD runs about $800 to $900. A lot more cost effective to replace individual components.
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.