Mazda VA and Ua engines - Design & Engineering discussion in Forkliftaction's forums

Discussion:
Mazda VA and Ua engines

Looking for information on how to remove push rod tubes from the head. I have to replace the o-rings at the bottom and can't figure out how to accomplish this. Please help.

Posted 26 Aug 2008 22:17
Discussion started by jim_v
Michigan, United States

Post a Reply Report this post

Showing items 1 - 1 of 1 results.

Sort messages by:

We did that about 2 years ago. It's a little difficult but we removed the Distributor, Valve and side covers, and valve rods. We made a tool and pushed them from the bottom up threw the side cover opening. The engine was in an older Hyster S35XL I think. Hope this helps

Posted 27 Aug 2008 01:57
Reply by Prentice
Ontario, Canada

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.