hyster j40xmt - Technical Troubleshooting discussion in Forkliftaction's forums

Hyster J40XMT:
hyster j40xmt

So I have this hyster come in for breaks adjustment. It's an electric with 2 drive motors. I went to adjust the brakes and found the rotors worn out. So I disconnected the brake line and pulled the calipers,replaced the rotors put new brake pads on hooked up the brake lines. I hooked up my brake bleeder to the top bleeder ports and try to bleed the brakes I'm getting some brake fluid but not a solid stream of fluid. The master cylinder seamed to be ok when I got the truck but my pedal is still soft. Any help?
thanks

Posted 7 Feb 2014 01:16
Discussion started by nitetime
Michigan, United States

Post a Reply Report this post

Showing items 1 - 2 of 2 results.

Sort messages by:

yep sometimes bleeding the air out of the system can be tricky
like mrfixit said
reverse bleed the system
if you have a pressure bleeder you can use that to assist in the bleeding too.

Posted 9 Feb 2014 23:52
Reply by swoop223
North Carolina, United States

You've been swooped!
swoop223@gmail.com

Post a Reply Report this post

Not sure how your brake bleeder works but sometimes you have to push fluid up from the bleeder ports on the calipers to the master cylinder to get the air out. A clean pump and squirt oil can with a hose connecting to the bleeder nipple works good.

Posted 7 Feb 2014 08:59
Reply by mrfixit
New York, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.