Geroj Can you also lend me some assistance with Jungheinrich EFG218K Error codes 008/ 035/ 068/168 respectively
anything will help
Digital outputs 08=DO4
02 Wire breakage A wire breakage has been detected on the respective output. Check wiring!
Troubleshooting aids:
remove the connector and measure the resistance on respective terminals of the plug connector to check
the individual valve coils.
On-off valves typically have a 15 to 30 ohm coil resistance.
If several outputs are reporting broken wires, an interrupted common return line is probably the cause.
If the resistance measurement cannot detect a problem, the cross-section of the common return line may
be too small.
Hi there.
I have the some fault as you. Blank screen and fault code 0802 on a jungheinrich efg. Can you help at all. Many thanks
Brilliant. :)
I already sent it.
about 18 megabytes
you got it?
technicalsupport*metaluxsa=com
change the star with @ and = with.
thank you
Ioannis, i think the problem is in the contactor 52018885. We had such an error.
Ioannis
XXXXX at yyyyyy dot com.
Or in profile.
hello any help you can send me at e-mail
[email address removed]
thank you
Hi Laci.
Console you own this machine?
MCF / JGH?
I have a number MCF if you need?
I tried to buy in Hungary.
Can not.
Ioannis has also mail?
hello nothing comming to my e-mail
Hi
Used electronics ACS 8025?
The same machine as mitsubishi EP40-50.
I sent the email link Check.
Hello Arin. can you send this manual for my?
best regards, Laci