Hyster E60XM - F108 ....Steer Motor not working - Design & Engineering discussion in Forkliftaction's forums

Discussion:
Hyster E60XM - F108 ....Steer Motor not working

Hello,
Popped code for worn/low brush - installed new brushes - now the motor will not work at all - no codes - Checked fuses - OK - Contacts burnt but are not pulling in. Anyone run into this problem???. Will wait while i bang head against wall -lol

Posted 16 Oct 2009 01:55
Discussion started by Prentice
Ontario, Canada

Post a Reply Report this post

Showing items 1 - 2 of 2 results.

Sort messages by:

Found the contact assembly sticking/hanging up. Replaced with a whole contact assembly. Works good

Posted 16 Oct 2009 23:03
Reply by Prentice
Ontario, Canada

Post a Reply Report this post

is the steering controller ok. sometimes get water in them also check the encoder on the column

Posted 16 Oct 2009 03:09
Reply by kevin_k
dumfriesshire, United Kingdom

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.