Error code "EE" and "C9" - Technical Troubleshooting discussion in Forkliftaction's forums

Toyota 5FBE20:
Error code "EE" and "C9"

I have previously resolved a "C9" alarm using the "analyzer" diagnostic to actuate the motor contactors. I was in the middle of doing the same when I was interrupted. Now when I turn the key on the control is flashing the "EE" alarm and the "C9" alarm. I cannot use the "Analyzer" diagnostics when the "EE" alarm is active. HELP.

Posted 8 Sep 2022 03:40
Discussion started by GlenMc
Missouri, United States

Post a Reply Report this post

Showing items 1 - 2 of 2 results.

Sort messages by:

Thank you for your reply, I did as you suggested for the "C9" alarm and verified that all contacts are neither welded or sticking. The analyzer troubleshooting is disabled because of the "EE" alarm. I followed the repair manual recommendations with no success, but is suggests for each alarm independent from the other could be caused by a bad CPU. I am investigating having the CPU inspected.

Posted 9 Sep 2022 00:26
Reply by GlenMc
Missouri, United States

Post a Reply Report this post

Check for a welded line contactor

Posted 8 Sep 2022 06:54
Reply by andrew_k
England, United Kingdom

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.