1. Home
2. Forums
3. Design & Engineering

Discussion:
Cat M60B

we have a problem with curtis BDI & silver box causing slow hydraulics after minimal use from full charge. Battery is good and fully charged. have tried adjusting SG level pot but no different. customer would be happy to live without battery alarm.
Does anybody know how to by-pass this, we know it's wrong but customer is always right!

many thanks

• Posted 20 May 2009 19:24
• Discussion started by steve_h
• West Midlands, United Kingdom

Post a ReplyReport this post

the 933 is a BDI with a controller box (8 terminal board and 2 pots)
if the hydraulics are slow its most likely not the 933
it will lock the hyd out completely if its hooked up right

check for bad connections at the motor or anywhere in the lift circuit

• Posted 20 May 2009 23:53
• Reply by justinm
• New York, United States

New York, New York its a heluva town..you know that The Bronx is up..and I'm Brooklyn down

Post a Reply Report this post

BDI's generaly switch a negative on or off for the lift soleniod when the battery voltage is low.. Not sure what you mean about the silver box.... Have tried replacing the BDI?. Or checking the negative for the BDI?

• Posted 20 May 2009 21:28
• Reply by julesrobdog
• Western Australia, Australia

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.