Alarm 235 on mode 3.0 - Maintenance & Troubleshooting discussion in Forkliftaction's forums

Discussion:
Alarm 235 on mode 3.0

Heli CPCD25

Tell me the reason for this error please

From Admin..You must use English Language please.

Posted 5 May 2024 02:36
By Sergey_Malkov
joined 5 May'24 - 1 message
Russian Federation

Mal

Showing items 1 - 3 of 3 results.

Sort messages by:

A CPCD25 is a diesel. The code you describe sounds like a code from an electric. In the zapi manual for a dual ace2 it states it to be a hardware fault in the controller. If you confirm the full model (engine or version of electric) I can see what I can find. Below is what I found.
"This alarm occurs when a mismatch is detected between the setpoint for the
overcurrent detection circuit (dependent on parameter DUTY PWM CTRAP, see
paragraph 8.2.6) and the feedback of the actual threshold value.
Troubleshooting
The failure lies in the controller hardware. Replace the logic board."

Posted 23 Jul 2024 23:12
By David_Friesen
joined 20 Jul'23 - 13 messages
Ontario, Canada

Post a Reply Report this post

2,5 Diesel?

Posted 23 Jul 2024 06:03
By Sunnysmile
joined 4 Jul'17 - 12 messages
Moscowskaya, Russian Federation

Post a Reply Report this post

?? 2,5 ??????? , ??????????

Posted 23 Jul 2024 06:02
By Sunnysmile
joined 4 Jul'17 - 12 messages
Moscowskaya, Russian Federation

Post a Reply Report this post

Post your Reply

Forkliftaction accepts no responsibility for forum content and requires forum participants to adhere to our rules of conduct. Click here for more information.

If you are having trouble using the Discussion Forums, please contact us for help.