hi gents
ive brought home a 35rrtt198.
have been charging the (11x 2volt cell) battery with the worst cell isolated. it shows 23.6v (with surface charge included....)
im getting nothing at all at truck...no light, no movement, no sounds,(though i did briefly hear a motor spinning and a gurgling sound)...
after having read plenty here tonight, im going to start tomorrow by looking at the fuses, the cards, hydraulic oil level and maybe motor brushes...
any advice for a newbie is greatly appreciated!
ps. is this machine a goody?, ie, can be kept operational fairly cheaply?
cheers
pps was quoted 300 for the manual!!! omg!!
([email address removed])
(ohfortooatethreeforonethreefourtwo)
Showing items 16 - 20 of 20 results.
the voltage stays above 19 but not by much...19.6 v.
dont think its enough...
i got it wrong earlier...
when the thumb button is depressed while moving joystick up,...a second motor,(in addition to steer motor) runs...
the trigger button cycles through the 3 modes but nothing from any...
Now that you have oil in the steer pump, are you able to reach, tilt, and sideshift?
yeah back again...
put another 5 l of hyd32 oil.!!
**** must have nearly been mt!!
pump a lot quieter now.
if i depress the thumb button and go down on joystick, a second, higher speed pump runs...nothing moves as a result though...
Thanks the swift reply!
Beginners mistake!, must stand in truck to get the pump gurgling...
put 5 lt of grade 32 hydraulic oil in tank and still gurgling......****!
ill check what the volts drop to...
i think 4 of my 12 cells are crook...
the pump that i can hear running is the steering...
nothing fwd or backward, up or down as yet....
only the steering so far.
Surface charge seems sufficient, but after turning the key on... what voltage drop do you get? If it drops to 19v, the truck will not work
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.