Hi Guys,
I have a major problem with my electric Linde Forklift, one day it just stopped going forward or reverse, over the last year I have had three technicians out to it, two of which said it was the drive ecu. Both of these had the Linde diagnostic set up on their computer! One of them actually managed to borrow another working ecu and plugged it in and hey presto nothing! So at present I am lost as to what to do with it, both technicians have told me to scrap it. The third said it may be the wiring loom but wasn't sure and didn't want to do it so I am stuck ! Does anyone have any suggestions?
Showing items 16 - 30 of 33 results.
Hi, Yeah both directional indicators are working, could it be a seat switch stopping it working?The year of manufacture is 2005 it's an E 25, ??
yes 32 are software, not a code. You can not seen in dash the error. It is a older Linde truck 336 type i mean. Do you seen direction indicator on dash?
Hi Okay the no first on the display is 32 then it changes to hours used also when very first switched on a series of eights come up but I presume this is just the display initialising. I hope this helps, nothing to lose,its scrap if we can't figure it out!??
I'll have a look tomorrow thanks
Ok
Is there any number on the display ?
The hour meter should change and show another number
Hi , just to let you know the directional arrows are coming up on the dashboard
Sounds good I guess you'll know what you're talking about, I have not got any software for it unfortunately but I'll check tomorrow about the directional arrows??
I spent years building them and reach trucks in Basingstoke
Best around
Hi thanks lindetecnz I will have a look in the next couple of days and get back to you, I appreciate you taking an interest ??
Firstly are the green directions arrows coming up on display?
Do you have diagnostic software?
set accelerator in good calibration.
be sure the direction lever give good signal , check led on dashbord forward and backward.
check sensor steer axle setting correct, or calibrate it.
when not drive check in diagnostic pc wich error give , it like not a big problem and not a control card
Hi , Yes it lifts and tilts it has side shift and extending forks all of which work and it has one travel pedal.
Firstly do you lift/tilt etc?
Does the machine have one travel pedal or 2
Hi ,
Unfortunately it hasn't it's looking like I'll have to scrap it, I have since posting another company look at it and they cannot find the problem.I look forward to your comments on this nightmare!
Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.