1. Home
2. Forums
3. Technical Troubleshooting
4. Jungheinrich
5. ERE 20

Jungheinrich ERE 20:
ERE OR ETV

hello friends
anyone have the ERE ot ETV's fault code
I met the ere several times
It' too hard ,only several fault cod
NO where to start

hope for your reply
BEST REGARDS
KUN SHER

• Posted 13 Aug 2012 23:50
• Discussion started by shar_k
• SH, China

E-mail:kunshar@qq.com;xiakun223@163.com

Post a ReplyReport this post

hi thanks for that will check cabling - if controller is it necessary to replace all control boards or is there any way to identify which one might be faulty? Is there a board for each motor?

The two top boards have a green and red led each one of them is flashing red only.

There is some corrosion on the board at the very back and bottom of the controller module which may be the problem.

• Posted 30 Nov 2012 07:53
• Reply by towbar27
• louth, Ireland

Post a Reply Report this post

One of the three motor phases cnnot be switched on, check motor wires or replace controller.

Regards

• Posted 30 Nov 2012 05:51
• Reply by nacsand_n
• Madrid, Spain

Post a Reply Report this post

Hi would appreciate this info also.
We have a 2002 etv c16 Fault code 18 - which is a controller fault - machine has no functions working.

martin. mccreesh at esatclear.ie

• Posted 27 Nov 2012 22:05
• Reply by towbar27
• louth, Ireland

Post a Reply Report this post

JH ERE and ETV have differents codes depending of what kind of controler has each one. I can help if you are able to give me more information, controller type... 1505F 1510 1514 4514 etc etc and error codes

• Posted 7 Sep 2012 04:50
• Reply by luis_y
• Lima, Peru

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.