sc4000 no tilt down - Design & Engineering discussion in Forkliftaction's forums

Discussion:
sc4000 no tilt down

Anybody ever had this problem.
SC 4000. Tilts up but when i tilt down the pump and motor run but it will not tilt everytime, it has new pump,sv1 valve and counter balance valve.

Posted 3 Aug 2016 04:44
Discussion started by Ward
Georgia, United States

Post a Reply Report this post

Showing items 1 - 3 of 3 results.

Sort messages by:

tilt interlock module was the problem

Posted 9 Aug 2016 08:55
Reply by Ward
Georgia, United States

Post a Reply Report this post

Thanks popeye ill give it a go if the tilt interlock block is not the problem ill know monday

Posted 4 Aug 2016 02:32
Modified 5 Aug 2016 05:19 by poster
Reply by Ward
Georgia, United States

Post a Reply Report this post

Check your pressure at the test port by the control valve. You need a certain pressure reading to overcome the counter balance valve to tilt down. If not enough try adjusting RV1 or it might be bad

Posted 3 Aug 2016 19:33
Reply by popeye
Ohio, United States

Post a Reply Report this post

Post your Reply

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

Having trouble using the Discussion Forums? Contact us for help.