Forkliftaction.com

DISCUSSION FORUMS : Forkliftaction.communicate

My forum profile

Printable version

Discussion Forums Home

Forum:

Mechanical Troubleshooting

Brand: Caterpillar - Model: DP40

Number of messages: 8

START MESSAGE:

blueford
Arizona, United States

Had bad fuel and everything was gunked up so I cleaned all the lines and the tank changed fuel filter added good fuel primed it and it wont start Im not getting fuel to the injectors or out of the fuel injector pump but the fuel filter has fuel in it any help or sudjestions would be greatly appreciated.

Posted 20 Jul 2006 05:59 AM

Report this message

REPLIES:

Sort replies by

simon_a
south yorkshire, United Kingdom

HI SOUNDS LIKE YOU NEED TO TAKE THE INJECTION PUMP OFF AND HAVE IT RECONDITIONED WHILE YOUR AT IT TAKE OUT THE INJECTORS AND HAVE THEM TESTED AS WELL. CONTAMINATION WILL HAVE GONE PAST THE FILTER AND INTO THE PUMP SOMETIMES THERE IS A LITTLE GAUZE FILTER ON THE INLET SIDE OF THE FUEL JUST AFTER THE BANJO BOLT ON THE PUMP BUT I RECKON PUMP WILL BE DAMAGED.

Posted 28 Jul 2006 02:28 AM

Report this message

Daniguzo
Texas, United States

IF THE FUEL SYSTEM GOT CONTAMINATED, IF THE ENGINE TURNS BUT YOU ARE NOT GETTING FUEL OUT FROM THE INYECTION PUMP... THE INYECTION PUMP MAIN SHAFT MAY BE DAMAGED...

-------------------------
don't be afraid you can fix it.. mas vale mania que fuerza..

Posted 14 Sep 2007 03:48 PM

Report this message

maluccio_g
France, France

Hi, see the little filter down at pump gasoil (non pump injection)

Use key n°27 to open , just a little filter conic primary.

Best,

Posted 29 Sep 2007 05:09 PM

Report this message

fixit
bury, United Kingdom

check last chance filter in pump under big nut on fuel in fitting and i would hope you have tryed bypassing feed to shut of sel.

Posted 22 Feb 2008 09:02 AM

Report this message

carl_v
Pennsylvania, United States

make sure shut off lever on pump is in run position.

Posted 22 Feb 2008 02:04 PM

Report this message

carl_v
Pennsylvania, United States

make sure shut off lever on pump is in run position.

Posted 22 Feb 2008 02:05 PM

Report this message

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

FORUM GLOSSARY

Click for description.

FORUM

DISCUSSION

MESSAGES

NICKNAME

SIGNATURE

FORUMS

Discuss: Industry News & Whispers

Discuss: Conferences, trade shows & other events

Discuss: Mechanical Troubleshooting

Discuss: Technical arena. Did you know? Who knows?

Discuss: Machines. Forklifts, stackers, telehandlers, container handlers and reach stackers

Discuss: Business issues

Discuss: Safety, training & legislation

Discuss: Fun at work