Forkliftaction.com

DISCUSSION FORUMS : Forkliftaction.communicate

My forum profile

Printable version

Discussion Forums Home

Forum:

Technical arena

Discussion:

BT RRB1 @ B2 Error codes

Number of messages: 7

START MESSAGE:

yaledude
Co. Tipperary, Ireland

when i switch on the truck eror code c29 shows and beeps, is this the service reset code and how can i reset this without having the can bus

Posted 3 Apr 2009 06:02 AM

Report this message

REPLIES:

Sort replies by

andrew_k
England, United Kingdom

Yes its the service reminder, without the can bus key you cant do anything.

Posted 3 Apr 2009 06:38 AM

Report this message

upliftUK
leicestershire, United Kingdom

if the canbus isn't looked then it is posable to do it without the key.

-------------------------
kjghkjhkh

Posted 3 Apr 2009 03:48 PM

Report this message

Leon_W
Tyne & Wear, United Kingdom

Hello upliftuk. i have a customer that asked for speeds to be reduced, so i used the key and changed the parameters. customer was happy. but on 3 out of 5 trucks the operator can access parameters 1 to 10 without the canbus key. is there a way to turn this off. Operators keep raising the speed back to full speed.

Posted 4 Apr 2009 00:16 AM

Report this message

powerlifter
united kingdom, United Kingdom

There is a parameter that locks the max speed regardless what the operator does but this can only be done using the can key.
Service count down parameter C29 can be switched off but only with using the key the canbus (controlled area network) cannot be switched off or locked

Leon are all the trucks AC or are the other three DC if DC the parameter to slow speed has to be done on the A5 card.

-------------------------
A good engineer is a helpful engineer

Modified 4 Apr 2009 04:15 AM
by poster.

Report this message

uplift
lincoln, United Kingdom

I'm guessing the the one's they keep changing is the newish one's with a key Pad? ( from September 2004)

parameter 39 locks the can system:
1 = Ignition, open
2 = Ignition, locked
3 = Keyboard, open
4 = Keyboard, locked

Set the parameter to 1 or 2 if only three drivers/truck profiles are to be programmed and a key is used to start the truck. If using a keyboard and up to ten drivers/truck profiles are to be programmed, set the value to 3 or 4. With the latter, the value must be programmed for each driver.

-------------------------
upliftuk@gmail*com (*=.)

Posted 4 Apr 2009 06:31 AM

Report this message

powerlifter
united kingdom, United Kingdom

That is only for driver accessibility so he can use his own key code but the engineer can over ride all this by programming the truck to a set speed.

-------------------------
A good engineer is a helpful engineer

Modified 4 Apr 2009 07:12 AM
by poster.

Report this message

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

FORUM GLOSSARY

Click for description.

FORUM

DISCUSSION

MESSAGES

NICKNAME

SIGNATURE

FORUMS

Discuss: Industry News & Whispers

Discuss: Conferences, trade shows & other events

Discuss: Mechanical Troubleshooting

Discuss: Technical arena. Did you know? Who knows?

Discuss: Machines. Forklifts, stackers, telehandlers, container handlers and reach stackers

Discuss: Business issues

Discuss: Safety, training & legislation

Discuss: Fun at work