Forkliftaction.com

DISCUSSION FORUMS : Forkliftaction.communicate

My forum profile

Printable version

Discussion Forums Home

Forum:

Technical arena

Discussion:

Clark TMG15S intermittent error code 10

Number of messages: 2

START MESSAGE:

rich_l
Colorado, United States

I don't have a service manual on this truck. Does any one have any ideas? The trucks right side drive wheel locks up. Very intermittent. Have to cycle key to clear code. Possible Steer pot problem? Thanks

Posted 4 Mar 2009 08:01 AM

Report this message

REPLIES:

Sort replies by

andrew_k
England, United Kingdom

Assuming its on a GE controller

Manual quotes

Steer angle potentiometer voltage is too high

This status code will be displayed when LP12/RP12 is greater
-10 than 3.9 volts.

SYMPTOM
Control will not operate.
POSSIBLE CAUSE
Steer angle potentiometer input mis-adjusted
or defective. Loose or missing connections at
P9 or P12 of either controls.
• Input voltage at P12 should be less than
3.9 volts at all times. Insure the proper
adjustment of the steer potentiometer.
• As measure at LP12/RP12 (wire #19) when
the steer wheel is centered = 2.15v, full
LH tum = 0.73, full RH turn = 3.53v.
Defective control.
• Replace control unit

Hope this helps

Posted 4 Mar 2009 09:12 AM

Report this message

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

FORUM GLOSSARY

Click for description.

FORUM

DISCUSSION

MESSAGES

NICKNAME

SIGNATURE

FORUMS

Discuss: Industry News & Whispers

Discuss: Conferences, trade shows & other events

Discuss: Mechanical Troubleshooting

Discuss: Technical arena. Did you know? Who knows?

Discuss: Machines. Forklifts, stackers, telehandlers, container handlers and reach stackers

Discuss: Business issues

Discuss: Safety, training & legislation

Discuss: Fun at work