Storing your login information automatically.

When you select the 'Remember me' option, your login information will be stored on your computer in the form of a cookie. When you visit Forkliftaction.com again, the stored login information will be retrieved automatically and you will not have to submit your login parameters (email address and password) each time you want to visit our members-only pages.

A cookie is a small piece of data that is sent to your browser from a web server and stored on your computer's hard drive. A cookie can't read data off your hard disk or read cookie files created by other sites. Cookies do not damage your system.

Marketplace Business Directory Discussion Forums Spec-Checker Industry News Events Calendar Jobs & Resumes Photo Galleries
Marketplace
Business Directory
Discussion Forums
Home
My profile
Search
Spec-Checker
Industry News
Events Calendar
Jobs & Resumes
Photo Galleries




Ningbo Ruyi
News service and business centre for materials handlingHOME
Search  
DISCUSSION FORUMS : Forkliftaction.communicate
Forum: Mechanical Troubleshooting
Brand: Crown - Model: 35RRTT
Number of messages: 6

START MESSAGE:
rick_o
Pennsylvania, United States
unit will not travel forward or reverse contactor no attempt to pull in ev 1 system any help greatly apreciatted

Posted 12 Feb 2009 09:30 AM Reply  Report this message
REPLIES: Sort replies by
Prentice
Ontario, Canada

I had a problem with the bottom foot switch. also check wiring to control system.

Posted 12 Feb 2009 11:46 PM Reply  Report this message
joe_y
Washington, United States

Definite control problem, check inputs to card (TB-11)  Possible brake or directional switch input

Posted 13 Feb 2009 00:32 AM Reply  Report this message
rick_o
Pennsylvania, United States
brake switch at motor continuity ok but would not carry current, replaced both foot switch and motor brake switch operates great
thanks for input

Posted 13 Feb 2009 06:49 AM Reply  Report this message
FootHill
California, United States
I only have 11volts at forward and reverse contactor coils.
  I'm sure this is supposed to be batt. Voltage?
  
  Still operates but forward contactor pulls in slow. (Not fast and snappy as reverse). And occasionally forward does not pull all the way.

  Any ideas on most likely reason contractors have reduced voltage?
   Thanks.

-------------------------
Be safe out there!

Posted 9 Dec 2012 05:40 AM Reply  Report this message
edward_t
South Carolina, United States

recent trucks (like since 1996) have a pulsed signal to hold the contactors, as it takes much less current to hold then to pull in.  the voltage you read may be the pulsed average.
just a suggestion, (for foothill) but starting a new thread for a new question on a differnet truck may get you a more clear answer.
I am pretty sure that ev1, which was in the original posters truck, did NOT have a pulsed signal to the contactors, and if you have a truck that old, then I would be asking about where you had the meter's leads connected.    
slow contactor operation may well be because of the insulation/guides having worn groves where the moving tip rubs.

-------------------------
webhome = http://forktechs.com
"it's not rocket surgery"


Modified 10 Dec 2012 00:22 AM
by poster.
Reply  Report this message


Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.
FORUM GLOSSARY
Click for description.

FORUM
DISCUSSION
MESSAGES
NICKNAME
SIGNATURE

FORUMS
©Forkliftaction.com
Forkliftaction Media Pty Ltd
PO Box 1439
Milton QLD 4064
Australia